14Point7 Spartan 3 Wideband Lambda Controller Kit
The Spartan 3 wideband lambda controller from 14Point7 adds CAN Bus output for use with ECUs including Megasquirt 3, Link, and any other standalone with CAN Bus input. The fuel mixture can be read from 8.82 AFR rich to over 50 AFR lean, providing greater control of your tune. Separate grounds for sensor heater and electronics reduce noise and improve voltage protection, increasing the accuracy of the sensor. An option to delay the sensor from heating for up to 10 minutes whilst exhaust gases increase the sensor temperature to 350°C prevents the sensor from being damaged during startup, extending sensor life.
Features
- 10ms Response Time
- 1x Programmable Linear voltage output for Lambda/AFR/%Oxygen
- 1x simulated narrowband output
- Compatible with Bosch LSU 4.9 and Bosch LSU ADV sensors
- Lambda range of 0.6 Lambda to 3.4 Lambda, equivalent to 8.82 AFR to 50 AFR for gasoline
- %O2 range of 0%O2 to 21%O2
- Lean Burn mode for lean burn applications
- CAN Bus support for the following ECUs; Megasquirt 3, Adaptronic, Link, Haltech, as well as YourDyno dyno controller are supported. More supported devices coming soon via firmware update
- CAN Bus output of Lambda or %O2
- Smart Heatup; RPM Triggered Heating of the oxygen sensor for MS3 ECU.
- Smart Heatup; Temperature Triggered Heating, Spartan 3 will wait for the Oxygen sensor to be heated to 350C by engine exhaust gas before heating up the sensor
- Does not require Free Air Calibration but FAC is available. Recommended only for clone LSU 4.9 sensors
- Compatible with Torque OBD for Android to display AFR
- Onboard FTDI based serial-USB converter
- ARM Cortex M4
- 0.1% tolerance components for all components that affect accuracy
- 4 layer Printed Circuit Board
- Separate grounds and power connections for LSU Heater and electronics for improved noise performance and improved voltage protection
- 2-year warranty